Control Valve Accessories - UV-5A(B)T(C)
UV-5A(B)T(C) Control Valve Accessories
This is an accessory for the Control Valve
Contains: Liquid Filled Gauge, Female Quick Disconnect
This is an accessory for the Control Valve to accept a Pressure Gauge Assembly
Contains: 90º Elbow, Tee, Shutoff Valve, Low Pressure Switch N.O. and Male Quick Disconnect.
This is an accessory for the Control Valve to accept a Pressure Gauge Assembly
Contains: Shutoff Valve, and Male Quick Disconnect
This is an accessory for the Control Valve
Contains: Low Pressure Switch N.O.
This is a replacement part for the pump port of the Control Valve.
NIPPLE PUMP INLET 2" GRV.
Contains: Grooved Nipple.
This is an adapter to convert the jack and/or tank port of the Control Valve to grooved.
ADAPTER 2" GRV UV5AT JACK/TANK
Contains: Grooved Nipple.
This is an accessory for the Control Valve
Contains: Low Pressure Switch N.O./N.C.
EECO Valve Troubleshooting Kit for UV-5AT(C) & UV-5BT(C). Also available for UV-4R and UV-7B(C) Control Valves.
This kit provides parts commonly required during control valve service
Contains: Valve Catalog, Troubleshooting Guide, USB Flash Drive, Combo Wrench, 110vac Coil (Black Wire), 220vac Coil (Black Wire), Dynamic Seal Kit, and Solenoid Kit
This is an accessory for the Control Valve
Contains: Liquid Filled Gauge
FEMALE QUICK DISCONNECT, 1/8"FEMALE
This is an accessory for the Control Valve
Contains: Female Quick Disconnect
MALE QUICK DISCONNECT, 1/8"FEMALE
This is an accessory for the Control Valve
Contains: Male Quick Disconnect
1/8" SHUT OFF VALVE, MALE X MALE
This is an accessory for the Control Valve
Contains: Shutoff Valve
1/8" 90° ELBOW, MALE X FEMALE
This is an accessory for the Control Valve
Contains: 90O Elbow
Right Hand Jack Port Adapter Kit for the UV-5AT(C) Elevator Control Valve, Part # 5709. Contains: 1 Right Hand Adapter Assembly, 1 Grooved Adapter, 1 Groove Clamp
A Dynamic Viton seal replacement kit (P/N 5131D) for your in-service UV-5A series valves (including UV-5A "S" series, UV-5AT and UV-5ATC valves). This kit contains the O-Rings for the moving parts of 3 Valves.
Since January 2001, all EECO valves have been manufactured with Viton seals. If you are replacing any of the major components listed on this page (which are supplied with Viton seals) in an EECO valve manufactuered prior to January 2001, EECO recommends that you also replace the older valve seals in the remainder of the valve with the newer Viton seals.